Selleys Brick & Concrete Silicone 415g

1. Thoroughly clean and dry surface from oil, dirt and grease with mineral turps.
2. Cut the tip off the cartridge and cut the nozzle at a 45° angle.
3. Fit the nozzle to the cartridge.
4. Place the cartridge into a caulking gun.
5. Hold caulking gun at 45° angle and gun sealant ahead of nozzle ensuring product is pushed into the joint.
6. For a smooth finish, a tool with a spatula is dipped in soapy water.
7. Clean up before sealant skins in 5-10 minutes, with a cloth dampened in mineral turps.
8. The sealant will cure in 72 hours.
9. At this point, any unneeded sealant can be removed by trimming with a sharp blade but avoid under-cutting the seal.

Limitations:

• Not paintable. Complete painting 7 days before applying sealant.
• Not suitable for use in below waterline applications.
• Do not use in below-ground applications.
• Not for use on polyethylene, polypropylene or Teflon.
• Pre-test plastics before use.

Cautions:

• Use in well-ventilated areas.
• Avoid contact with skin and eyes.

Tips:

• For neater joints, mask sides before applying sealant and remove the tape before sealant skins.
• When first applying the product, extrude a small amount onto a piece of scrap material to ensure a smooth continuous flow of silicone sealant.
• For a better finish use, a spatula dipped in mineral turps or detergent and water to tool off the sealant.
• Work in sections that can be completed before sealant skins.