Selleys Araldite 90 Seconds Epoxy Adhesive

Selleys Araldite 90 Seconds Epoxy Adhesive

A fast set adhesive, Selleys Araldite 90 Seconds epoxy adhesive comes with 2 separate parts and works in 90 seconds to eliminate long clamping times.

Features:

• Chemical reaction between 2 parts makes it stronger.
• Multi-purpose.
• Clear post-application.
• Initial bond forms in 90 seconds.
• Can hold up to 75kgs (per cm2 when used on steel).
• Water-resistant formula.
• Dries rigid to form a lasting, durable bond.
• Surfaces do not need to fit closely (gap fills a little).

Usage:

• Can be used on Bakelite.
• Temperature above 65°C weaken the bond but it is regained once the temperature drops.
• Decorating glass, stone or clay items with pebbles, shells or stones.
• Repair household items, toys and sports equipment.
• Any cured product can be made more pliable with heat and scraped off for removal.
• Clamp or tape up for a stronger bond.
• Smaller quantities will allow for flexibility in working times. Large quantities will cure faster.
• For the tube variant, use the correct cap for the correct tube. An incorrect cap will cause the product to harden in the tube.
• For any repositioning, the product will need to be reheated. Make sure the surface is heat resistant, heat up to 150°C in an oven. Once the product seems softer, reposition and let cool. The product will cure again once it reaches room temperature.
• In colder weather, a longer bonding time may work best.

Can be used on:

• Plastics (except for Polyethylene or Polypropylene)
• Rubber
• Crystal
• Metal
• China
• Glass
• Wood
• Leather

How to use:

Tubes:

1. Ensure surfaces are clean and dry.
2. Break the seal for each tube with the spike on top of the cap.
3. Thoroughly mix both parts in equal quantities. Post mixing, it can be used for 1 minute at a temperature of 20°C.
4. Put the mixed component on both surfaces to be put together.
5. Bring them together and apply slight pressure.
6. Make sure that no unnecessary strain is applied on the surfaces for at least 30 minutes. Use tape or clamps if required. For maximum strength, allow 8 hours.
7. Clean any unused product with acetone and replace the cap.

  Syringe Nozzle:

1. Ensure surfaces are clean and dry.
2. Remove the plunger cap and make sure to cut the seal at the tip carefully.
3. Dispense liquid onto a clean surface and thoroughly mix both parts in equal quantities. Post mixing, it can be used for 1 minute at a temperature of 20°C.
4. Put the mixed component on both surfaces to be put together.
5. Bring them together and apply slight pressure.
6. Make sure that no unnecessary strain is applied on the surfaces for at least 30 minutes. Use tape or clamps if required. For maximum strength, allow 8 hours.
7. Clean any unused product with acetone and replace the cap.

Available in 2 sizes: 14ml and 24ml.

Have a look at our wide range of Adhesives and Sealants!